NEWS: I have started a Patreon for my 3D modeling gig.
If you would like to support my work here please visit.
I decided to make a modular dice tower the other day, and this is the result. It's totally modular, and stacks well.
I like the modular design because I can mix and match as I see fit, and only print one section at a time so it doesn't take forever to print.
I printed it 80% for the photos, and this works well for 12mm dice. Doesn't work well for 16mm because it's a little too small.
** Updated Tray STL with the fixed version from Kadrim, found here: http://www.thingiverse.com/thing:1777445 with their permission.
** Check out a remixed tray from dreamingDemon here. https://www.thingiverse.com/thing:2829731
I made sure to print with 200% first layer width to get it to stick better.
I used Tinkercad to design this, building up a basic unit first, then modifying the unit to add decoration, and a base, and top off of that first unit.