Case for the arduino mega + ramps 1.4 with a fan, and an optionnal setting for DIY Printrite to clip it on base rods.
needs 11 x M3*8mm screws and nuts.
2 versions of bottom box:
-one for the PrintRite mount setup
2 versions of the top box:
-one simple, easy print
-one with the "RAMPS" text, bridge challenge
Please note that there is a support part for the bottom box, show in red here
you should mount it in this order:
1 - remove the support part
2 - set the rods mounts if you print this version (mount it directly on the printer or set only the 2 X-rods now and mount it on the printer at last moment)
3 - set the arduino (without the shield), insert the back of the arduino in the supported slot and push it onto the holes mounts.
4 - set the front face. At that moment the arduino should not move anymore.
5 - set the reset button into his hole.
6 - carefully plug the ramps on the arduino.
7 - set the fan and the fan filter on the back face.
8 - get all your cables throught the back face and set the back face in place.
9 - plug all the cables, insert nuts into there slots and close the case.