This is a microcopter developed for a microquad workshop in Fab Lab Seoul.
FPV equipment embedded under the flight controller.
It is very light and fast to print so you can replace it very fast in case of crash.
-motors designed for 7mm class
-optional 6mm motor mount
-electronic mounted on the top for more accuracy
-lipo protected on the bottom ( semienclosed)
-arms design very resistant but flexible for absorbing crashes
For this model the fpv equipment is:
-Coaxial wire as dipole antenna
-Microcamera 600tv 3gr
-Polulu voltage regulator or another 150mah lipo for clean/separate power supply
All the electronic and motor are easy to access.
The motor holders are flexible so you can attach motors 7-6mm size.
For the test model the flight controller used is microwii with dms2 receiver on board but a wide variety on flight controllers can be mounted.
Full tutorial here:
Very tolerant model you can print with almost any settings. Printing without supports it is possible if the speed is 80mm/s or higher on a well calibrated printer