It is not pretty, but it is original.
This started as test doodle with Sculptris, but for once I was able to finish it without destroying everything. Turned out nice print, so I wanted to share it.
You can use and remix this, but with attribution and not for commercial use. It did take time and creative work to sculpt this.
Mouth and nose should print without supports, if you lay it on back. Make sure ears gets support, Cura had some attitude problems but try tweak support angle until it generates enough support.
48mm from nose to back of the head it did print well enough with 0.2 layers, but I'd use 0.1 next time or scale it bigger.