Simple cover, to hide the cables on the Quanmun v1 Goggles. Video receiver mounts nicely to it. Rectangular hole on the side is for a power switch, Switch i used was 16x8mm (included sketch file if you need to edit anything). Hole on top is for the power cable, mounting the battery of the back of the headstrap balances it nicely.
For attaching it to the goggles, I pressed it in place (so the pins and tab on the edge mark the brim of the goggles). Then, by hand with a suitably sized drill bit, opened up the holes and cut the rectangular tab with an exacto blade. Bottom (side with pins) is hot glued to the goggles brim. Top side (with rectangular tab) simply slots in once the cables have been connected and tucked away. Video receiver attached with double sided tape.
Head-strap buckles and mounting tabs also included (4mm holes)