PS4 Stand with Legs that run the length of the console and so it's very stable. The parts can be printed together on the same plate or separately and will fit on a 200x200 Platform. The legs are adjustable by about 1cm on each side and so you can make a good fit before gluing them.
I left about 10mm of room on all sides of the All4One file in case you have glass on your bed and can't print all the way to the edge. This will also allow for a skirt in case you're printing with ABS so that you don't get any lifting.
You can use any kind of glue to attach the Legs to the Front & Back, BUT, mine fit so well that I didn't have to and the same goes for the PS4.
Supports are only necessary if your printer can't bridge a 20mm gap. This gap is on the underside where the legs attach.
I printed these without supports since you only have to bridge ~20mm. But if you're printer can't do this, make sure to use supports where the legs attach to the front and back.
If printing with ABS, I recommend using a Skirt. This can be done on the All4One file too as I left about 10mm of room on all sides.