instructions by H3R0M4T3
BUY INSTRUCTIONS :
Buy at least one M4 bolt with a length of 16mm and two M4 nuts to fit on (in my case the material has been brass, but you can take any metal you want, except uranium.. that is bad stuff).
PRINT INSTRUCTIONS :
For printing the model, take a slow printing speed (32mm/sec) and give the model a density of at least 32% and a wall thickness of at least 0.8mm. Well that's what i would recommend, but i know, that you know your 3D-Printer a lot better than i do.
BUILD INSTRUCTIONS (reference to the pictures) :
Step 1 :
Insert the nut into the mount at the handle.
Step 2 :
Screw the bolt from the bottom of the handle through the nut on the top and give it a nice, but gentle last turn (PLA is durable, but not indestructible ;)
Step 3 :
Insert the second nut into the mount at the top-head-razor-blade-bracket
Step 4 :
Sandwich the head together (If this is the first bringing together of all parts, leave the head without the razor blade in order to prevent injuries)
Step 5 :
Screw the handle into the top nut of the head (needs some force, but not brute force)
Step 6 :
Turn the handle until the top thinner part can't be seen anymore. (This takes probably brute force)
Step 7 :
Take the cap and push over the razor head. The bolt will refuse to get pushed into the cap, but this is constructed in that way, to achieve a nice and snug fit of the cap. So take your time, push is a few times in and out , to make a nice slot for the bolt, IF IT IS STICKING OUT OF THE HEAD !
Congrats, you build your very own safety razor <3
"Step 8" :
If you insert the blade, try to push is to one long side of the head.
This will give you a more aggressive side (more blade is exposed) and a more gentle side (obvious, less blade is exposed).