This pin is a proper scaled pin with smooth lines designed specifically for 3D printing. The design is our own and the measurements for scale were taken from a Brunswick regulation pin.
Results work best with a 1.6mm shell and bottoms, you save a lot of plastic on this model by using a thicker perimeter, top and bottom and less infill. I recommend if you use less outer shell increase the infill.
Will print without infill but it is rather flimsy in PLA without infill.
Sliced best with Cura 15.04.4
If using Cura 15.04.4 or better we recommend using a brim for platform adhesion as this is a tall model with little contact surface to the plate.