UPDATE: added files for the case you dont want to use a display or a complete extern display. the two new files also made to take a 80x80mm Fan. :)
New Clips for mendelmax and tmax Frame are up. (latest Clips only work with latest case files)
optimized part "lid-fan-Display.stl", new uploaded. now with a Clip to hold the Display cable in place and a fan-guard to protect your fingers... ;)
case with cable-hole on the airguide side and closed at the bottom. (one of the bottom holes should only be closed by 2-3 layers and could easy cut open if needed)
This is still "Under Construction" Remix of the Case i did for Rumba with
Full Graphic Smart Controller -> http://www.thingiverse.com/thing:516447
The Knobs and the Airguides of the original do fit into this Remix:
check the "Remix" section for more...
The display-Frame is also the same part as in the original. Case and Lid/Fan/Display Holder part are changed. i also integrated a hinge to work with open case...
the Clips are made to Clip the box on a mendelmax Frame with 70mm distance. you can also fix the case with M3x10-12mm screws directly to the extrusions. the hole distance is 50mm. that one hole wich is placed under the arduino mega pcb Needs to be a m3x6-8mm one without a spacer. if the head of this screw is higher than 3mm it touches the pcb!!! be shure to have enough clearance at that Point!
with a 60x60x25mm fan you need to lift the mendelmax around 30mm up to get clearance for the fan. if you take a 60x60x10mm one you need 20mm between the extrusions and your table.
this Thing is not printed by myself Jet and i guess i dont need one any time... so please if you print one upload a few pics and give me Feedback how the parts fit in the comments.
the hinge needs support the way ist done at the moment. hopefully i get an idea of how to get rid of this...
you need a few m3 screws ans nuts. m3x20 and m3x16 in most places. the lid Needs one Long screw, it Needs to be around m3x33mm.
after printing first Mount the Case directly on the Frame or on the Clips. one of this screws is not reachable if you put the arduino mega in first.... m3x20 with no nut on the underside should fit too. the holes in the case are 2.8mm Diameter so the should came out as tight fit for a m3 screw.