This is a base added to StormTrooper Resculpt by Geoffro, http://www.thingiverse.com/thing:362947/#made . On thingiverse antering page I could not chose the ''REMIX'' button.
I wanted a stand for the helmet and , as I am using transparent filament I printed the whole thing painting only few particoular so that a led could light clearly . I believe it lights also when using other colored filament .
If you want the version with led ,
you will need
° led (the common leds work at 1.5 - 3 V )
° 300 Ohm resistor
° savaged electical wire
° rock switch (my drawing comes with 15 x 21 mm one)
There are two STL file , one is for the stand with NO Led and one is for the mounting Led one , this means the base has the hole for the switch, as said a 15 x 21 mm rock switch .
Inside the stand there is a MN21 battery holder http://www.thingiverse.com/thing:1258021 glued on inner top surface , it is cabled like in the attached Jpeg scheme. Resistor can be mounted either on negative pole. Led pins polarity can be easily discovered by watching the two parts inside the plastic : the smaller one is always the + . You don't need solder , you can just weave cables together. Don't forget to print your StormTrooper helmet with low infill otherwise the Led won't be able to light inside the plastic . And afterall you have to make a hole inside the head , just use a 10-12 mm drill bit .
Printed with CURA , it automatically infilled the inner part of the base in order to be able to build the to part of the round box . In this way I easily broke the support and mounted the rock switch and battery holder .