Mounts the board (and not the entire camera) from a Playstation Eye to the X carriage belt clamp holes using long screws so it attaches to the underside. I removed the IR filter from my Playstation Eye and discovered this makes it focus only extremely close to the lens ( somewhere between 1 cm and 3 cm depending on the zoom setting). So I made a mount with the idea of watching extrusion up close and at high speeds (up to 125 fps with modified driver .config).
Print mount, attach to bottom of the outer 2 X carriage belt clamp holes with long screws, attach PS Eye board to cylindrical part with angled holes.
I realize a horizontal cylinder doesn't print well, but it does save on plastic and keeps the holes in mostly the right place. If you want to improve it, go for it!
EDIT: I changed the spacing of the holes slightly (~1mm) to align better, and also increase the diameter of the hole for the PS Eye board screws by 0.5mm to make them nominally the same size as the holes on the PS Eye board.