An improvement over Butterfly v04.
The supports are better designed and the antennae are wider (0.648 diameter) for easier print.
Also, I re-calibrated the printer which generated a much more precise result over version 04.
B9C 1.1 with software 1.4
Spot-A-HT version 7
50 xy and 50.8 z
first 2 layers at 10 seconds, then 2.5+3.5
time 39 minutes and resin about 2.2 ml
Supports (in mm when with 3 decimals):
slope ratio 0.30
base 0.500 (about 9 layers)
support height 3.500 (it took time but it was easier to detach than shorter)
support size 1.500
touch point 0.700
enters in the model by 0.050
tip relative length 0.90