This is my third print and the first with supports.
It takes about half an hour.
Some features are very small: the antennae are just 0.56 mm wide. They were printed correctly.
The tail is 2.68 mm wide at its thinnest point.
The wings are 2.4 mm thick.
The supports detached quite well, but they do leave very visible marks, which one should sand down.
Edit: "Butterfly supported HD resin v05" on here is a better version to print.
Spot-A-HT version 7 (reused multiple times).
B9C 1.1 and software version 1.4
4 base layers, 2 cured at 10 seconds. Other layers at 3+2.
The supports are:
2.750 mm spaced from each other
0.60 slope factor
2.500 mm high and 2 mm of diameter
0.700 mm at the contact point
0.060 mm is by how much the contact point enters into the object
0.90 tip relative length
the resin used is about 3.1 ml