Like many of us I have an EZ3D printer. Many have given up the fight to make the thing working good, but I keep updating the unit.
I didn't like the fact that the PSU was separate from the actual printer unit. I have designed this holder to keep the Power Supply Unit attached to the bottom of the frame. That way the printer can be moved easier.
There are two versions. One has a push in connector for the 8mm rod.
The second one has cutouts for ZIP ties to hold the 8mm rod.
Both work and fit the frame.
You will need M3 screws and 2 T-NUTS to attach the holder to the frame, You will also need at least 4 more M3 screws to attach the PSU to the holder itself.
I've just uploaded the new version of the PSU holder. This one has countersunk holes for the m3 bolts that hold your Power Supply, and I changed the bottom holes to SLOTS to allow some play fr the bolts. I've also added a side so it's a bit more sturdy...
Be careful with your M3 screw length. I've used 10mm bolts with a m3 washer underneath. If your screw is too long you might short out the PSU!!!