This is the second remix I made of the original low poly mask. Upon opening in MakerBot Desktop you will probably notice the strange orientation. This is due to the fact the original Replicators build plate was not large enough to fit this lying flat. For this version you will have to use a raft as well as support.
For those of you with larger build volumes download the file Masquerade_flat.stl, as it requires much less support.
*I have never printed the Masquerade_flat.stl since I made the original over a year ago an only intended it as a one-off. My only printer at the time was an original Replicator.
*I used adafruits.com Diffused 5mm Slow Fade Flashing RGB LED. They are great for beginners as they don't require any programming skills. Use the wiring diagram above for help with resistor selection and LED placement. If you would like to use a different power source or lights use this website to help you http://led.linear1.org/led.wiz.
-Check to see if lights fit in place as PLA has a tendency to warp
-Once you are sure the lights fit, glue them in place with a fast drying adhesive that works well with plastics
-Solder lights in place with their associated resistors
-To connect the mask to the battery pack, I used male/female DC Connector Size: Out-side diameter 5.5mm, In-side diameter 2.1mm. I used adhesive to mount this wire to the left edge of the mask passing right in front of my ear and down my back.
-I used a silicone adhesive sealant to seal all the exposed LED leads and wire.
Disclaimer: I make no claims that this mask is actually safe to wear. I am not liable for any injuries caused by electrical shock. MAKE AT YOUR OWN RISK
-The stap is made by sewing 3/4" velcro strap made up of 3"of the "hard" side of velcro and the rest is made up of the "soft" side of velcro.
-I trimmed a piece of soft cotton from a fabric store. This is held in place with velcro sewn to it so it can be washed.
-To stop light leaking into your eyes causing flares in your vision, use a dark opaque material such as electrical tape to black out the eyes. as an added effect of the tape the mask become creepier.