Earlier this week I sat at a TechShop and laser cut the attached enclosure for my custom Ultimaker 2.
Please note any of the files with laser etching have been flipped to show the mirror image. So that the etchings will be on the inside surface when mounted.
Also the top enclosure piece is setup for my custom E3D mount (http://www.thingiverse.com/thing:992952). And since it's off center of the 6mm bearings the hole in the top enclosure is also off center. When I have a chance i'll make an alternative version for everyone else.
One fun note, the front panel already has some extra screw holes added. So that I can come back later and turn the opening into an acrylic door with a couple 3d printed hinges.
UPDATE: Need a knob and hinge for the front panel? Irishbeard did an amazing job. His design is now on my printer. http://www.thingiverse.com/thing:1259626