Min and max end stop mount for, all three versions of
Easily change your home position, stop working in the same corner. Position your material where ever you want.
I printed these in PLA and they have to flex a lot to get over the rails but they seem fine after repeated tests.
If you have followed this project you probably know I am against end stops. Maximums can be very useful for when you mess up your gcode, the machine will stop if it goes too far. This works on all axis for a minimum or maximum position indicators. The ramps board will accept all 6 at once.
Wire it in the NO position and no firmware changes will be needed for the MPCNC.