My own version of an 18650 dispenser that doesn't need to hang off the edge of a table or shelf nor require a heavy object to keep it from toppling over.
It's base is a little chunkier, which provides room for a finger or two to pick the battery out even when placed in the middle of a desk.
It's designed to require as little print supports as possible, so I've chosen to not make this as minimalist as other dispensers as it would have require more supports to be printed thus wasting plastic and adding no strength. Only two supports are required, one under each vertical overhang in front of the curved part of the tray.
-Rotated the model so it's facing the correct way when importing.
-Added a slightly wider version for those who use protected batteries
-After several requests I've added a taller ten battery version for both Protected and Unprotected versions. They are untested and you will need a rather large printer to print them. I may add an extension for the shorter 5 battery designs if there is enough interest.
Printed in ABS
.2mm layer height
.4mm layer widthwith
May need to re-orientate to right side up to print.