Printed this Garden Rooster at about 250% and he turned out really good. There is a little bit of loose filament on underside of his butt, and at the very base of the wing tip, but I don't believe it's anything a heat gun can't take care of. Like him so much that we'll probably take him up to the CR 10Pro so we can shoot for 350% at the size I could fit on my Ender bed he's about 9.5" tall and 9" from beak to tail.
Just added photo of the larger model at 343% it's about 12" Tall with a layer of BBs in the bottom to weigh it down.
Cheap & Crappy PLA