I printed this in vase mode scaled to 145% which made it 174mm tall. I wanted to test the upper print height limit of my machine. My printer's published max height is 180mm, but I think that is a bit of an exaggeration. If I printed something that tall I think the wires coming out of the extruder motor would be smashed against the upper frame - see photo 3 taken at 99% through the print. there's not much room left above the extruder! but all turned out great.
Generic cheap PLA from eBay. PLA
Printed in vase mode (spiralize outer contour) in Cura 4.4.1. Printed at 145% scale, 174mm tall. Print took 1 hour and 45 minutes. The vase is surprisingly sturdy even though the walls are one layer thick.