Benchy printed on my Ender 3 Pro with 0.2 layer height and sliced in Prusamod Cura on super cheapo eBay PLA filament. I'm still new to this, but I think this Benchy came out decent, almost no stringing and archways look good. Little bit of sagging on the straight doorway, but that's my only complaint (speed was 60, so possibly too fast).
Bottom lettering not very good, but I wasn't getting good adhesion for the lettering. First layers are usually solid as I installed an ABL probe, I suspect initial layer jerk settings are too fast for all the quick directional changes for lettering.
Generic PLA From eBay PLA