Ridiculously fun with 6000kv 1106 motors and a 500-1500mah 3s.
Amazon Basics PLA
Ensure you use motor mount screws short enough, or with enough washers, that you do not touch the motor coils with the screw. A thicker motor plate would have been welcome in my case with the screws included with my motors, but if you have access to shorter M2 screws or, as I did, stack a couple M2 washers to take up the extra space, it works well.
If you print in PLA, ensure your motors are not getting hot every couple minutes when you start out. PLA gets very soft under heat, and a motor could easily pull through if you are not being vigilant.