Tomb
Made by Gamgan, uploadedDescription
Love this print, very easy to do, had to hold the sides together with rubber bands while it dried, I used gorilla glue to glue them together. Not installed the gates yet but will do so soon. Was very easy to print and very clean.
WARNING
Minutes after you finish printing this tomb, you will find there is a remix that is super buffed up and make you wish you would have seen the remix first, I printed mine crazy slow, it was like 12 hours the bottom, then 13 hours the top then 9 hours per 2 sections of wall. I am sure I could have done it faster but I am still learning how to slice my files and am very far from efficient. I used the Fat Dragon Terrain profile.
Print Settings
Printer Brand:
Printer:
Rafts:
No
Supports:
No
Resolution:
Fat Dragon Terrain profile
Infill:
20
Notes:
Make sure you check out the remix first!!!