Printed on a nearly stock Monoprice Maker Select V2.1 (Wanhao Duplicator i3) at 0.06mm resolution and 30mm/s print speed to reduce wobble. As recommended, I printed with support as the slider mechanism would never be able to print successfully without that.
The only problem I encountered was making sure I dug out all of the support material, as it can sometimes look like you got it all, but it didn't quite come off. I cleaned up the supports and minimal amount of print mess using a craft knife, a razor blade, and a small Swiss Army Knife. The hardest part was getting the support material from where the switch slides into on the bottom.
Overall though this item was essentially perfect out of the box. Thank you so much to RetroGameRevival for making this awesome restoration piece for this oft-neglected console.
Monoprice Maker Select v2.1
3D Solutech PLA
Silver (Would've used red but I don't have any)