Hi all. This is my make of the hi capa kit. I have made a few personal changes to the kit just to make it fit me better. The big change being the stock. I used the stock off my cyma ak which isn't a normal buffer tube connection. I saw the original back plate and it looked very similar to the connection so i took some measurements and with two fails, i made the adaptor and it works perfectly. The only other difference is I split the receiver into two (you can find the file in the remixes) as I have a smaller printer. I also get my tag on it which didn't turn out the best. The only problem i have with it is the fit for thr rail which is so tight.. It is extremely hard to get out so be careful. I also didn't have any of the correct screw so i used some PC fan self threading screws which worked perfectly. My one big suggestion is a cut out on the right side so you can see the chamber in case the is a jam. If you do jam you would have to take apart the hole thing or there is any other problems. I did drill the charging handle to make the hole bigger as it was chatching the guid rod and when you pushed it forward it would pull the rod.
Craig you have done a very good job and I can't wait till V2 comes out. Eitherway really good kit and if someone has a full auto Hi capa it be a great smg alternative!
Make sure you use good adhesive for some parts and have some sandpaper on hand if you need it.