OWL Filament PLA
Printed it without supports, made a 4mm Brim, probably wasn't neccessary, but it didn't separate so that's always better ;)
Extruder and Bed Temps were taken from the owl-filament.de Homepage.
Reused 100% of the components from several broken Electric and Electronic devices.
Jack and Resistors were taken from a crappy Multi-Component Tester that wouldn't work oob.
Fan came from some 1970s Linotype printer and the PSU is from an old Laptop.
Powerswitch and LED were donated by an old USB-Deskfan.
Screws were taken from an old and bent PC-Case. Cooler Master brand, I think.
Had to change the charging port to a Rectangle type with a dremel (no 3D-Design skillz yet).
Also had to upgrade the Resistor to a 12K Ohm (LED was burning up otherwise).