Jeep Grand Cherokee SRT8
Made by stephanes, uploadedDescription
Rescaled to n-scale (1:160, or 30.13mm length) and printed on the Anycubic Photon at 0.02mm layer size. Increase the axle size to 2mm (worried the wheels would snap off otherwise, and removed some z-fighting polygons from the sunroof (not sure if those would cause a problem, but felt safer removing the extra faces).
Print Settings
Printer Brand:
Anycubic
Printer:
Photon
Rafts:
No
Supports:
Yes
Resolution:
20 microns
Hey, Great print! What support size did you used (light, med, heavy)? I also have an Anycubic and have some issues with support structures. I think its the resin...
The supports were a collection of light and medium, and the models are rotated 15 degrees. I set it up using Chitubox (the Anycubic Slicer is based on the Chitubox slicer, they look almost identical). As for the resin, this is just the Anycubic translucent green that came with the machine.
I tried taking a screenshot of the supports.
Note that I resized the models to 1:160 scale, and in the case of the jeep, I replaced the axle (was worried it would break otherwise).
By the way, your models look awesome! I like that you have a mix of regular cars too, not only high performance or expensive cars. I'll be using some of these on an N scale railroad layout.