The Pale Green Tower of Chance
Dusk & Kiwi
Wonderful model, really enjoyed making it. Total print time was 64h 12m.
Used some floors from
The floor with the banner, the 3rd randomizer floor and the ruined top
I also made a small knob in TinkerCAD to go on the top plate so I could remove it easily.
I was not able to get the OpenLock clip to work, seemed to be too big to fit the available spaces so I glued the base together instead, and glued the 1st floor into position as well. The rest all use the magnets and so the tower is customizable, short, tall, random, however I want it, which also adds to the great design.
The magnets I got were so powerful that after putting the lower ones in a section they flipped the upper ones to match the polarity, it REALLY clicks together.
A couple of suggestions for very minor improvements;
- Increase the width of the base by about 1mm at the back to allow for the 1st floor to fit in easier
- Add magnet holes in the base and the bottom of the 1st floor so it can snap into place as well.