Nightmare Before Christmas silhouette
Made by Strathetes, uploadedDescription
This was a rough print, something must have gone wrong. My best guess is to make sure your bed is very very level before trying this scaled up, minor balance problems created large numbers of adhesion failures.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.3mm
Infill:
20%
Hi thanks for your post. yes i used mirror tile and glue stick for my first print but didn't like the Finnish from the glue on the bed. On the second i used the mirror clean. printed at the max my bed would allow 215mm with a small brim. had a small lift but not too bad. bltouch fitted helps a ton.