Supports were much easier to remove from between her legs, since the opening was larger. Very happy with the quality coming off my Prusa, would look even better in resin, but I don't have a resin printer yet, lol.
Auto-generated supports in Simplify3D, with some extras added where the auto supports didn't get placed. Axe was printed at a 65% angle entirely on supports aroudn the hand gripping the axe, approx 2 mm off the bed, with a solid bottom layer to the supports and brim to ensure the support column didn't pop off the print surface.
Note to 3dprintedtabletop: The middle of the axe head was fairly thin (I think I had to enable single wall extrusions for it to even attempt to print), so it might be worthwhile to thicken the axe head/blade just a bit so it would be easier to print on an FDM printer, if that isn't something too hard to do :)