Back
Filament guide for Ender 3
Made by yashrg, uploaded
Description
I really like the design. It printed really well laying flat on my Ender 3. I turned the object so it was printing diagonally thus giving it some more room. I also used supports so the channel that's supposed to fit onto the aluminum extrusions didn't warp. I did however go with an infill higher than I probably needed because I really didn't want anything to break(I anticipated myself fighting with the part a little to get it onto the extrusions but there were no such issues)
BTW, I know I need to move the filament spool to the right so the smaller arm is also supporting the filament.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.1
Infill:
80%
I did notice that in the original design, the pegs that hold the rollers in place are pushed all the way through the holes in the mount. However, my pegs ended up printing a little too big to be fed all the way through. I might need to adjust their size and make them a little smaller.