MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.
you sure about that strut angle ?
No! I'm a total beginner. https://youtu.be/wT_rfSqjdLU
They are in the deepest position.
try n keep as level/ straight to bottom of the sponson is a good place to start theres a lot of negative angle in your pic
Thank. I will try.
I think my boat is to heavy. I would try 4s batteries, but then its 250g heavier.
negative angle on strut will push nose into water pos will lift nose
Thats why i made it in this negative angle. I thought if i'm slow, the rear is to deep in the water. I hoped it pushes it a little bit up.
you would be better to start with a neutral position and go from there.. ive just ordered my motor for my 36" 20% bigger version a whooping 5hp should push it nicely