Despite the dust, the print turned out well for my first 0.1mm print job. The last photo showing it mounted probably gives the impression of it being warped / not level, however that is 100% due to the angle of the photograph and the fact the sock around the nozzle is a bit caddywhompus.
Overall, it was quick print w/o any issues. Hard to complain about that. I'll update post-first print with any snags/complaints (if there are any).
--- Update ---
First print went very well. As another maker mention, there is VERY little room left to see the print once this is added (a couple mm's at most). You can adjust the screws on the housing to raise it if its too low but its printing fine for me as is and really only effects viewing the print at lower layers.
Sliced / prepared using Cura 3.4.1
- Default Printer settings for a CR-10
- Fine Quality 1mm
- Material set to generic PLA
Printed with Hatchbox PLA (black)
- Print Temperature - 200°C
- Bed Temperature - 60°C