1/144 Gunpla base
Made by Tbenge05, uploadedDescription
Printed at .1mm layer height w/ 20% infill on Monoprice Mini Delta updated with m_rozay's firmware (see Reddit's monprice mini Delta groups pinned post).
This base is perfect. the only no 3d printed parts are pegs which can be shipped from the runners that came with whatever model you built.
The design is great, don't know how else to say it. Definitely my go to print for bases now. I haven't printed the other 2 base plates included, yes there are 3 total!
Assembly was easy, I filed the holes out a bit - to clear some slop that came in at the interface with the printbed - and a little trimming on the gear teeth for the same reason.
The clips are great too. I feared they would snap (similar to parts on a different baseplate I printed previously) but they hold up well.
Great design! 10/10!!