Printed on alfawise u20. scaled the model up a bit, dont remember how much, 3-4ish times. .1mm layer height with no supports, on a raft. For some reason the axle didn't slice well in Cura, it had a large split running down the middle of the hexagonal portion. I was able to glue it together well enough and clamped the end down with a rusty locking washer so the axle didn't fall out of the holes. painted with craft acrylic paints. absolutely love the well body and roof models. it will be a working gnome well in my garden.
The bucket was also on found on Thingiverse
Scaled up like 3 or 4 times, not sure exactly. I used cura 15.04 and the axle didn't slice properly, it left several empty layers along the middle of the axle, causing the print to fail when I had all three parts on the same print bed together, printing separately produced usable results, though the axle is still wonky.