Rat
Made by Yin78, uploadedDescription
As always a pleasure to print your models. Great job!
Print Settings
Printer Brand:
Wanhao
Printer:
Rafts:
Yes
Supports:
No
Resolution:
0.2
Infill:
10%
Notes:
I think I would have preferred a hole in the black part of the nose. It was a bit tricky to glue it into place (I'm using superglue). But I eventually succeded.
I found the tail a bit tricky to put in place too. I don't know why because it fitted well without glue, but when I started off with the glueing it just didn't want to fit in the right position (as I assume it's supposed to touch the ground. The tail of my rat is stuck in the air. He is happy anyway.) But that's my fault and not the model.
Rat was one of my quicker models, I needed a Xmas present for a fan of the comic strip. Sizing is always a tough choice, I try to post the smallest version that can be printed well. Small parts leave little room for connection options.
FYI, I use E6000 glue when I put my models together. The glue gets tacky quite fast but takes much longer to set than superglue. This gives me time to ensure the parts are positioned correctly without worrying that the glue will set in the wrong position. Pros and cons for each glue.
Thank you for posting your make.
Steve