This is totally the best dragon sculpture EVER; thank you, Ajolivette, for sharing! I printed it in Bend-Lay, thinking that flexible material might make breakage less likely during support removal, but Bend-Lay is tough stuff so you have to yank pretty hard to get the support off. I broke it in 3 places but fortunately super glue is almost invisible on Bend-Lay. Printed using the Up/Afinia's "shell mode" which creates external support but no internal support at all. I want to try it in T-Glase next, if I can ever get T-Glase to work at all. I stupidly used a decimated version of the model and so probably lost a bit of detail; next time I'll print it full-res, at a smaller layer height, and with a bit less support.