Printed this on My FlashForge Finder using Hatchbox Wood Filament. Grateful that it came in multiple parts as my print bed is quite small. I had a few issues with the 3 bottle rack pieces lifting off the print bed on the right front corner (even with painters tape on my print bed). If you zoom in to the pic, you will notice it. But, it doesn’t look too bad for my first one. I was able to print 3 oil rack pieces at one time and then each of the sides, one by one. Luckily I printed the 3 racks first cause when I printed one of the sides and tried to assemble it, the racks did not fit into the 3 slots on each side piece. I had to resize the sides to 105% so the racks could fit into their respective slots. All in all, I love the look of this design compared to some of the other oil stand designs. However, the round compartments where the bottles sit could be another 1/4”-1/2” deeper so the bottles are more stable and won’t topple over if you accidentally hit them. Thank you so much for this design! I wish I knew how to use SCAD so I could tweak and modify this. Hope my review/comments help as you continue to perfect your design. Mahalo!