Printed on a Raise 3D N2 Plus using the Bondtech BMG dual extruder upgrade and PLA and Polysmooth used as support material since it will dissolve in alcohol completely and is cost competitive with PVA and other support materials like scaffold, except not prone to moisture like PVA.
0.1mm layer height and scaled to only 30mm high so that the width was less than the N2 Plus 25mm nozzle spacing so no ooze or wipe walls required. The slice review shows just exactly how fragile the print was with only barely a shell hollow tube per layer.

Raise 3D N2 Plus

Yes

Yes

0.1mm layer height

90%

Again scaled to be no wider than 24.4 mm to ensure wipe walls were not required making this only 30mm tall.