FireFlo v3
Made by Suisuicide, uploadedDescription
Perfect, I made one :)
I only use the top part up side down.
Used 8520 motors
The old hubsan Rx board fits perfect.
FPV tx03 camera.
Printed in petg 20% infill, 0,1 layer height.
Not the prettiest but can be assembled with only elastic bands in under 10 minutes.
Flies well outdoor, approximately 7 min flight time on 600 mAh battery.
Well done
Print Settings
Printer Brand:
Prusa
Printer:
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.1
Infill:
20
Frame weight approximately 4 gram. Very light