MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.
Works great. 2hr total print time on a Craftbot 0.2mm layer height, PLA, 40% infill
Does it actually fit with the top cover on the amiga? On my machine the PCB and USB port are sticking out too far into the opening of the floppy drive cover. It doesn't fit properly and will require cutting down the top cover of the amiga around the floppy opening.
You did remove the GOTEK circuit board from the case right? you don't use any of the original GOTEK housing. and Yes, I did a test fit, fits fine but I have to put the drive side on first and ensure the usb/buttons are sticking out before putting on the left side.
I had to trim the fake disk eject button part a bit, perhaps your sled isn't sitting fully flush because it needs the fake disk eject button trimmed a little on the left corner.