*edit This printer was printing too wide in the X axis... that is why my print is a chubby thanos... I did not compensate as I did not know it was doing it at the time, but it was actually quite a large amount. If you want to replicate my chubbier thanos, just increase the X axis of the model slightly instead of a uniform scale.
Not a fantastic output from the printer I was testing, but it was enough to get the job done. I did not test my belt tensions before the print, this is what happens when your belts go out of alignment on a big delta (the lines on the back of the chair are a good indicator)
No Sanding or finishing at all. I let the layers of paint do most of the hard work these days :)
0.2mm layer height
10 hours print
Printed on an effing big Delta in PLA
**Print shown is 19cm tall.