Printed with Hatchbox Glow in the Dark PLA at 210C and 60C heated bed on a Rigidbot regular with E3D v6 hot ends.
0.2mm layer height
Slide Pipes printed in corkscrew mode using Simplify3D slicing software. http://www.thingiverse.com/thing:703220
The parts printed well although the valves and valve body required quite a bit of sanding to get them to slid easily. The only real problem I ran into was when I went to play it. The sound is muffled so that means either the valves aren't sitting clean in the body and/or there are massive air leaks. Depressing any of the valves does not change the sound one bit as can be seen in the video ( https://youtu.be/m6l8ifwdLS0 ). I'm at a bit of a loss as the fit is snug and I used vaseline to "oil" the valves and create a good seal in there.
I'm open to any suggestions to get good airflow. Also, does anyone know of a good way to check for a good seal?