Made on ToyREP. Printed of 1.75mm ABS filament with E3D clone, 0.4 mm nozzle, heated by 40W ceramics cartridge.
Print took 2hours and 11min, used 2793.09mm of filament. See the video when frog was printed: http://youtu.be/jKKAmOBQOPk
- Slic3er 1.2.9
- Printrun 2015.03.10
First layer 20mm/s, 0.35mm thick, 225°C, 200% extrusion width, concentric infill.
Other layers 15-30mm/s, 0.15mm thick, 215°C, 30% honeycomb infill.
Retraction 1.5mm at speed 4mm/s, 0.05mm extra length on restart.
There is a bit of oozing at the back side of front legs and I had to use higher temperature for the first layer, so I damaged the bottom when peeling of the bed. But this is probably the best example of ToyREP capabilities so far.