Made on ToyREP. Printed of 1.75mm ABS filament with E3D clone, 0.4 mm nozzle, heated by 40W ceramics cartridge.
Print took 41min, used 1044.67mm of filament. See the video when box was printed: http://youtu.be/EWU0UEn7rfE
I did not use exactly this particular STL but a file I have since 2011. The shape is exactly the same, except for the skirt.
- Slic3er 1.2.9
- Printrun 2015.03.10
First layer 10mm/s, 0.35mm thick, 220°C, 250% extrusion width, concentric infill.
Other layers 15-20mm/s, 0.25mm thick, 210°C, 20% honeycomb infill.
Retraction 1.5mm at speed 4mm/s, 0.05mm extra length on restart.
The last layer is not printed completely. Again there is some part left unprinted in the middle. When bridge cooled down it bended quite a lot. That is very unfortunate property of ABS.