Made on ToyREP. Printed of 1.75mm ABS filament with E3D clone, 0.4 mm nozzle, heated by 40W ceramics cartridge.
Print took 34min, used 859.85mm of filament. See the video when box was printed: http://youtu.be/2YG8s9D8vsI
- Slic3er 1.2.9
- Printrun 2015.03.10
First layer 10mm/s, 0.35mm thick, 220°C, 250% extrusion width, concentric infill.
Other layers 15-20mm/s, 0.25mm thick, 210°C, 20% honeycomb infill.
Retraction 1.5mm at speed 4mm/s, 0.05mm extra length on restart.
The last layer have small square if infill left unprinted in the middle. Probably caused by Printrun. As a result of cold bed and ABS heat shrinkage bottom is not flat, and final cube is only 19.5x19.5x10mm big.