MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.
Could you please point me to a place where I could get semi transparent case like this.
Also. not sure if it has been asked, is this able to be used upside down(of course rotating the screen). Im right handed and it seems the joystick would be better on right side.
Can you send me your teensy code for programming it with the analog stick?
How would I connect the buttons to the raspberry pi?
Teensy (ATmega32u4 USB dev board) 2.0
You must have a very good printer! I had to put in my own supports for the extreme overhang areas at the front and rear of the bottom case. Even using Simplify3D it was still a challenge and took me 3 attempts.
Have you thought about also Installing XBMC and watching movies off a USB?
you can use Recalbox to have Media center.
I use that to play me
and how to remove the red square in the top right?
look at the two last photo
snes the screen and well
psx the screen and shift? psx, pcengine sega cd?
its makes you the same ?
What HDMI cable did you use? Did you need to cut it short and solder? Thanks
just remove the plastic has the conector ;-)
looks great! did it assemble alright for you?
awesome! is the red tape wrapped around a micro controller being used as a USB gamepad?
Teensy (ATmega32u4 USB dev board) 2.0 - ATmega32u4 ;-)
GPIO big shit ! no select & star !
did you manage to get the FPC extender board? They seem to be out of stock.