Ben Carlson firstname.lastname@example.org
7:13 PM (19 minutes ago)
I got my nimble installed and have the below things set up.
Voltage to E0 steper driver set to 0.56 (couldn't get lower)
Microsteps set in firmware to 1/4. Per the manufacture it should work.
Esteps set to 600.
Here is where I am running into issues. I am trying to calibrate my extruder. I measure 100 mm, send G1 E50 F300. This should give me 50mm. instead I get about 10mm. When I do the math it gives me 3000. I entered 3000 and something went wrong. The nimble did not extrude but did buzz a lot. Kind of stuck here. any suggestions?