Ok, so not sure if anyone else had has as many stupid issues with this printer like I've had. I seriously think they gave me an old frame with the new touch screen and wrong bed. I fixed the bed issue best I can and now for whatever reason it's extruding filament way too fast. I've tried to reduce the speed with g code and slicing profiles, but it just seems to ignore any commands. I have never received any replies from Tech support and not sure what firmware to use if I decide to flash this and not just strip it down for parts. I've found a couple of versions and have some exp with flashing firmware, just not sure about the touch screen or the newest/best firmware to use. I have the proper equipment to perform the bootloader if needed, just at this point confused with what I should try next. The filament just clicks and bangs during any print then finally chews it up causing jams in the hot end (replaced with all metal creality style hot end w .4 nozzle) I've also tried .6 and .8 with similar results and much crummier prints any help is appreciated
So i have a tronxy p802ma with a clone titan extruder and i was looking to upgrade the filament gear to a Hobb-Goblin gear but i m not sure how it would be setup as right now i have the pressed in gear that the titans usually come with. If anyone has any any advice or instructions that would be great. Thanks.
Fired up my X1 after it's been sitting awhile and I am met with this screen. I emailed support and they told me it is a firmware issue and gave me instructions on fixing it, but they did not work. I have attached photos of the LCD screen and a screenshot of the program they told me to use and the error. I appreciate any help I may receive.