I have sorted out most of the screen commands for my TronXY X5SA. But some baffle me. On my firmware, for instance, the "TPAdjust" gives me a blank screen, so I guess that does nothing. But, what does "default" do? I am guessing that it clears all user settings like the Z-point, maybe temperature auto sets. I have replaced my inductive Z sensor with a mechanical switch that emulates the voltages levels for un-triggered and triggered. I'd like to remove any other Z-height settings I have made, I THINK that Default will do that. Is that the consensus, or has anyone managed to pry a real manual from the TronXY people that actually helps?
...and it doesn't stop. I have to switch it off.
I bought this Tronxy x5sa off a friend. Was fully working. I had to replace the hotend which I did. The hardware is all fine. Just something amiss with the software, and as a total noob to 3d printing I can't work it out. Tinkering with the hardware has been easier for me. This is doing my head in.
This 'grinding' of the bed into the nozzle happens either [A] whenever I start printing a gcode I've made in cura (there must be some settings amiss but they seem fine), but [B] also happens when I select Z-offset on the printer controls. Before I can manually adjust the head/nozzle moves right round the 'outside' of the bed, then moves in and raises the bed into the nozzle, till again, I exit or manually stop it. The bed is full of big dents now and I'm pretty fed up with it all.
Hope someone can help. Much appreciated.
Does anyone have some G-code they can copy and paste so I can edit to pause a print to change filament? Like pause.... go home.... (I change the filament) Resume (How would I resume?)... Go somewhere and prime the new color and start printing again. I have an X5S with Marlin firmware SHORT_BUILD_VERSION "1.1.6". I use Slic3r through Repetier Host. Thanks in advance....
Does anyone have a good CURA 4.6.1 profile for X5SA?
I saw this post: https://old.reddit.com/r/3Dprinting/comments/eg01yo/tronxy_x5sa_need_help_with_cura_441_setting/
But it looks like there are some new options (see attached). Heated build volume?